NEWS

NEWS

Specializing in the production of various truck universal joint cross shaft assemblies, differential cross shaft series accessories

NEWS

What should be paid attention to when assembling the cross shaft universal joint
图片名称

2021/12/07

What should be paid attention to when assembling the cross shaft universal joint

After the parts are washed and dried in clean wash oil, check again the journal, bearing, oil seal, thrust washer (some cars do not have this washer) and other parts of the surface of the cross shaft. There should not be any defect.

READ MORE

Expansion sleeve and pulley failure and slippage How to reform
图片名称

2021/12/07

Expansion sleeve and pulley failure and slippage How to reform

This article quotes the customer’s long-term experience of using the expansion sleeve, and the transformation and redesign of the expansion sleeve connection structure not only meets the repair requirements, but also successfully applied in production practice and achieved good results.

READ MORE

The difference between universal joint and coupling
图片名称

2021/12/07

The difference between universal joint and coupling

After many years of experience, customers often purchase universal joints, which are confused with couplings. What is the difference between universal joints and couplings:

READ MORE

New type mechanical base part expansion sleeve
图片名称

2021/12/07

New type mechanical base part expansion sleeve

The expansion sleeve is a conservative basic element widely used in the combination of large load machines in the new domestic machinery today. In the combination of the wheel and the shaft, the coupling expansion sleeve is the pressure generated between the containing surfaces by tightening the high-strength nut A keyless joint installation that completes load transfer with friction.

READ MORE

How to install the universal joint correctly
图片名称

2021/12/07

How to install the universal joint correctly

To ensure the constant angular velocity of the rotary motion and the synchronous rotation between the main and the driven shafts, a double cross universal joint or two single cross universal joints should be used in combination, and meet the three conditions;

READ MORE

< 1...40414243 > proceed page